SOVENT A NEW SYSTMEM PLUMBING cont……

 

The sovent system design prevents the increasing of terminal velocity at every floor/unit by  its design. The cross sectional area always maintain a core of air to balance pressure changes.

While using Sovent in a stock need to install De-aerator at the end of every stack. Before that we must know about what is Aeration  .

Aeration is the process of  air  circulated through, mixed with or dissolved  in a liquid or substance.

Aerator falls into two general categories.

1)Air into the water

2)water into the air

The water into air method is designed to create small drops of water that fall through the air

The air into water method creates small bubbles of air that are injected into water steam.

Deareator fittings relive the excessive pressure which is created by transition of water flow vertical to horizontal flow.this fittings are full sized water ways with no flow restriction. It can be repaired by  traditional cleaning methods.

 

 

The nose piece restrict the vertical flow prior entry to horizontal drain.also that nose piece separate the air and water flow to the de aerator drain.it doesn’t contain any moving element to separate the air and water .

 

Deareator are required at the base of each stack with horizondal offset. It uses a pressure relief line connection which is adopted in the stock.it may be installed either above or below the  floor.

Conclusion

This system not utilized frequently even though it has advantages. So awareness about this product need to be increased by Plumbing Professionals, Plumbing Contractors, Plumbing Consultants, architects and builders.

 

It's only fair to share...Share on Facebook0Share on Google+0Tweet about this on TwitterShare on LinkedIn0

Leave a Reply

Your email address will not be published. Required fields are marked *